0.6mm CM Ultra-Thin Head Serrated Anti-Loosening Micro Screw

CM/CD pattern micro screws with compressed heads, built for high-volume automated driving.

Key specifications

Installationelectric or hand driver
StandardGB/T 3098.1 (mechanical properties), GB/T 197 (thread tolerance)
Typical substratephones, wearables, miniature modules
Key inspectionshead thickness, head diameter, thread gauging
Head TypeUltra Low Profile / CD-textured

Request a quote Request samples

Product overviewOverview

The head is where the height budget is won or lost. A standard pan or cheese head consumes 1.2–1.8 mm; pressing it down to 0.6–0.8 mm lets the screw disappear into a counterbore so the outer surface stays flat. The trade-off is torsional capacity: a thin head fails earlier, so fine-pitch threads and a drive recess sized to the head are used to spread the load over more turns instead of more torque.

installed by electric or hand driver.

Key featuresFeatures

C1018 carbon steel (carburised) or 304 stainless; nickel and zinc-nickel plating available for carbon steel.
Head diameter, head thickness and shank length can be tooled to drawing, with sample runs before mass production.
Head height 0.6–0.8 mm, allowing flush or slightly sub-flush installation in a machined counterbore.
Threads held to a 6g tolerance and gauged 100%, so automated feeding does not jam on pitch deviation.

Typical applicationsApplications

Notebook hinge covers and keyboard brackets
Camera modules and vibration motors
AR/VR headset temples and face-plate structures

Selection notesSelection

Set the driving torque from the head strength, not the thread strength, and confirm the limit with a destructive torque test on the actual lot.

Frequently asked questionsFAQ

How do I specify the 0.6mm CM Ultra-Thin Head Serrated Anti-Loosening Micro Screw?

Set the driving torque from the head strength, not the thread strength, and confirm the limit with a destructive torque test on the actual lot. installed by electric or hand driver.

What matters during installation of the 0.6mm CM Ultra-Thin Head Serrated Anti-Loosening Micro Screw?

Drive it with an electric or hand screwdriver. C1018 carbon steel (carburised) or 304 stainless; nickel and zinc-nickel plating available for carbon steel.

Specifications

Head Type	Ultra Low Profile / CD-textured
Standard	GB/T 3098.1 (mechanical properties), GB/T 197 (thread tolerance)
Installation	electric or hand driver
Typical substrate	phones, wearables, miniature modules
Key inspections	head thickness, head diameter, thread gauging

Manufacturing and inspection

Plated parts are checked for coating thickness to GB/T 5267.1, with corrosion resistance verified by neutral salt spray to GB/T 10125.Material certificates and dimensional records accompany each lot; material and dimensional records are supplied per batch.