Product Center · Blind Riveting

IP68 Pre-applied Adhesive Sealing Self-Clinching Standoff

IP68 sealing rivet stud listed under the rivet range, where bulge formation and stud squareness decide whether the seal survives.

Key specifications

Installationset from one side with a rivet-stud tool
StandardGB/T 17880 series (setting), GB/T 197
Typical substratesheet metal and extrusions
Key inspectionsthread gauging, perpendicularity, push-out
Drive TypeTorx Plus

Request a quote Request samples

Product overviewOverview

Perpendicularity is what makes or breaks the joint: a tilted stud misaligns the part bolted to it and introduces a bending moment during tightening. Stud squareness depends on the bulge filling the hole evenly. If the hole is oversize the bulge cannot fill it, the stud leans, and the sealant is compressed on one side while a gap opens on the other. Squareness is therefore a sealing parameter, not only a dimensional one.

installed by set from one side with a rivet-stud tool.

Key featuresFeatures

Oversize holes tilt the stud and unload the sealant on one side.
Stud length follows the panel plus the height the mating part needs, so the thread ends where the nut lands.
Body material is picked from the corrosion class of the installation, not from the sheet it sits in.
No spatter or heat-affected zone on the visible face.

Typical applicationsApplications

Automotive body attachments
Appliance panel mounting
Elevator and access-control hardware

Selection notesSelection

Where torque resistance matters, specify a hex or knurled anti-rotation body.

Frequently asked questionsFAQ

Why does a rivet stud lean?

Usually an oversize hole or a sheet thickness outside the bulge range, so the bulge cannot fill the hole evenly. Check hole size and sheet thickness before adjusting the setting tool.

What matters during installation of the IP68 Pre-applied Adhesive Sealing Self-Clinching Standoff?

Set it from one side with a rivet-stud tool. Oversize holes tilt the stud and unload the sealant on one side.

Specifications

Drive Type	Torx Plus
Standard	GB/T 17880 series (setting), GB/T 197
Installation	set from one side with a rivet-stud tool
Typical substrate	sheet metal and extrusions
Key inspections	thread gauging, perpendicularity, push-out

Manufacturing and inspection

Push-out and torque tests after setting record failure values.Alternative materials and finishes can be quoted side by side during sampling, so cost and corrosion resistance can be traded off explicitly.