Type 69 Pre-applied Anaerobic Sealant Rivet Nut

Open-end blind rivets for fast single-side fastening of sheet, plastic and composites.

Key specifications

Installationset from one side with a rivet tool
StandardGB/T 12615–12618 (blind rivets)
Typical substratethin sheet, extrusions, composites
Key inspectionsmandrel break load, shear strength, head contact
Surface TreatmentNylon patch / sealant pre-coating

Request a quote Request samples

Product overviewOverview

Joint strength comes from the expanded body bearing on the hole wall and the rivet head clamping the panel. Hole size and grip range must match: an oversized hole reduces expansion and shear strength, while a panel thicker than the grip range prevents the tail from forming. Countersunk heads need a matching countersink for a flush finish.

installed by set from one side with a rivet tool.

Key featuresFeatures

Dome, countersunk and large-flange heads for different faces and loads.
Aluminium, steel and stainless bodies to match strength and corrosion needs.
Mandrel head stays encapsulated, leaving no protrusion to finish.
One-side installation with a snapped mandrel leaving a back-side anchor.

Typical applicationsApplications

Automotive interior and body trim
Appliances and ducting
Racking and fencing

Selection notesSelection

For shear-critical joints use steel or stainless bodies; aluminium suits light duty and visible surfaces.

Frequently asked questionsFAQ

How do I specify the Type 69 Pre-applied Anaerobic Sealant Rivet Nut?

For shear-critical joints use steel or stainless bodies; aluminium suits light duty and visible surfaces. installed by set from one side with a rivet tool.

What matters during installation of the Type 69 Pre-applied Anaerobic Sealant Rivet Nut?

Set it from one side with a rivet tool. Dome, countersunk and large-flange heads for different faces and loads.

Specifications

Surface Treatment	Nylon patch / sealant pre-coating
Standard	GB/T 12615–12618 (blind rivets)
Installation	set from one side with a rivet tool
Typical substrate	thin sheet, extrusions, composites
Key inspections	mandrel break load, shear strength, head contact

Manufacturing and inspection

Shear and pull-out tests after setting record load and failure mode.Alternative materials and finishes can be quoted side by side during sampling, so cost and corrosion resistance can be traded off explicitly.