Product Center · Press-Riveting

Waterproof Sealed Self-Clinching Standoffs for Outdoor Cabinets

Sealed self-clinching standoff: a clinched column with a seal at the panel interface for enclosures that must keep water out.

Sealed Self-Clinching Standoffs (Waterproof Series)

Key specifications

MaterialCarbon Steel / Stainless Steel
Installationpressed into a prepared hole (single side)
StandardGB/T 90.1, GB/T 4208 (IP rating)
Typical substratesheet-metal housings requiring sealing
Key inspectionsleak tightness, seal compression

Request a quote Request samples

Product overviewOverview

A sealed clinching standoff adds a seal or seal groove under the flange. The clinch holds the standoff and the seal closes the annular gap around it, so the two features work at the same interface. Pressing force that is too high distorts the flange and unloads part of the seal, which is why the press setting is part of the sealing specification.

Material: Carbon Steel / Stainless Steel. It is pressed into a prepared hole from one side.

Key featuresFeatures

Press force affects the seal, not only the clinch.
Seal layer under the flange blocks leakage across the panel face.
Fixing and sealing in one pressing step, reducing assembly operations.
Seal material and compression selected to the required IP rating.

Typical applicationsApplications

Outdoor cabinets and telecom equipment
EV power electronics housings
Chargers and energy storage cabinets

Selection notesSelection

Set press force within the clinch window and verify sealing by test; a standoff that passes push-out can still leak if the flange is distorted.

Frequently asked questionsFAQ

Can a clinched standoff be sealed reliably?

Yes, provided the flange stays flat. The seal sits on the flange, so distortion from excessive press force opens a leak path even when the clinch itself is sound.

What matters during installation of the Sealed Self-Clinching Standoffs (Waterproof Series)?

Press it into a prepared hole from one side. Press force affects the seal, not only the clinch.

Specifications

Material	Carbon Steel / Stainless Steel
Surface Treatment	Zinc-plated / Stainless steel finish
Standard	GB/T 90.1, GB/T 4208 (IP rating)
Installation	pressed into a prepared hole (single side)
Typical substrate	sheet-metal housings requiring sealing
Key inspections	leak tightness, seal compression

Manufacturing and inspection

Leak testing at the pressure and hold time specified for the IP grade.We recommend a pilot assembly at the actual torque and mating part before locking the process parameters for volume.