6.35mm Standard Bit Set

6.35 mm bit sets covering common star, Phillips, slotted and hex sizes.

Key specifications

MaterialS2 Alloy Steel
Installation1/4-inch chuck on driver or drill
StandardDIN 3126, ISO 1173
Typical substratemulti-size assembly work
Key inspectionssize verification, shank dimensions, hardness

Request a quote Request samples

Product overviewOverview

A set earns its place by covering the sizes actually used and keeping them identifiable. Compartment marking speeds selection and makes it obvious when a size is missing or has been replaced with the wrong one. Bits wear at the hex shank as well as the tip, so kits usually include spares of the high-use sizes.

Material: S2 Alloy Steel. It is installed by 1/4-inch chuck on driver or drill.

Key featuresFeatures

Covers star, Phillips, slotted and hex sizes to avoid mid-job gaps.
Compartment marking keeps sizes identifiable and avoids mixing.
6.35 mm hex shank to DIN 3126 for universal tool fit.
25 mm and 50 mm lengths for confined spaces and deep recesses.

Typical applicationsApplications

Equipment installation and commissioning
Appliance and electronics service
Automotive and motorcycle repair

Selection notesSelection

Build the set around the recess types actually used on site; generic kits often lack the size that matters.

Frequently asked questionsFAQ

How do I specify the 6.35mm Standard Bit Set?

Build the set around the recess types actually used on site; generic kits often lack the size that matters. Material: S2 Alloy Steel. It is installed by 1/4-inch chuck on driver or drill.

What matters during installation of the 6.35mm Standard Bit Set?

Retire the bit once the tip loses its profile; a worn tip still turns but concentrates load on the corners Covers star, Phillips, slotted and hex sizes to avoid mid-job gaps.

Specifications

Material	S2 Alloy Steel
Shank	6.35mm
Hardness	HRC60-62
Length	25mm/50mm
Standard	DIN 3126, ISO 1173
Installation	1/4-inch chuck on driver or drill
Typical substrate	multi-size assembly work
Key inspections	size verification, shank dimensions, hardness

Manufacturing and inspection

Each bit is checked against its marked size, with tip accuracy sampled.We recommend a pilot assembly at the actual torque and mating part before locking the process parameters for volume.