135-6073-0094
PRODUCT CENTER
Bit Sets
Long bits from 75 to 150 mm for deep pockets and multi-spind
Long Bit for Automated Screw Machines
- MaterialS2 Alloy Steel
- Installationautomated screwdriving head chuck
- StandardDIN 3126, ISO 1173
- Typical substratedeep pockets and multi-spindle heads
- Key inspectionsstraightness, runout, tip dimensions
Product overviewOverview
The governing issue is stiffness. As length grows, the same side load produces more deflection, which shows up as runout at speed and misalignment between bit and recess, accelerating wear. Above a certain length-to-diameter ratio, the answer is a stiffer material or a larger shank, or a guide bushing that supports the bit near the tip.
Material: S2 Alloy Steel. It is installed by automated screwdriving head chuck.
Key featuresFeatures
- 75, 100 and 150 mm lengths for deep pockets and multi-spindle heads.
- Thicker shank or higher-rigidity material to limit runout.
- Tip accuracy equal to standard bits, preserving recess contact area.
- Magnetic collar or vacuum pickup available for different feed systems.
Typical applicationsApplications
- Automatic screwdriving machines
- Multi-spindle driving heads
- Deep housing assembly
Selection notesSelection
Choose length from module stroke and bushing position; extra length amplifies runout and loses torque.
Frequently asked questionsFAQ
How do I specify the Long Bit for Automated Screw Machines?
What matters during installation of the Long Bit for Automated Screw Machines?
| Material | S2 Alloy Steel |
|---|---|
| Length | 75mm/100mm/150mm |
| Hardness | HRC60-62 |
| Standard | DIN 3126, ISO 1173 |
| Installation | automated screwdriving head chuck |
| Typical substrate | deep pockets and multi-spindle heads |
| Key inspections | straightness, runout, tip dimensions |
Overall length, tip dimensions and straightness are checked on a projector and runout fixture.We recommend a pilot assembly at the actual torque and mating part before locking the process parameters for volume.
